The exact capabilities of this device varies by radio model.Ĭopyright 2019-2021, Universal Radio, Inc.
#ICOM RS BA1 VERSION 2 SOFTWARE#
This software is designed to operate with Windows® 7, Windows® 8.1 and Windows® 10 on a PC with 1.8 GHz processor or better, 150 Mb HD, 1024x768 resolution. The IC-7300 can be connected to a PC via a USB cable and the input/output audio signal and CI-V command is sent through the USB cable. Our friends at the TX Factor have produced a video that logically goes through the step by set process of remote controlling an Icom Amateur radio, more spec. The Icom RS-BA1 IP Remote Control Software allows you to use an Icom compatible radio installed in another. Remote control software provides a user interface, similar to the radio's front panel, and allows you to control the radio from a remote location. The RS-BA1 is compatible with Icom transceivers that input and output audio through a LAN or the USB port. Too bad ICOM doesnt provide the software for those of us that have already made the investment into their radios. System configuration software sets up IP address, audio sampling rate and other settings.Ģ. Yes, Please could someone upload RS-BA1 V2.11 and a key, I would love to try this software. The Icom RS-BA1 IP Remote Control Software allows you to use an Icom compatible radio installed in. The RS-BA1 Windows® CD consists of two component software applications:ġ. Icom RS-BA1 v2 Software Amateur HF Transceiver Options. Allowing you to remotely operate a selected transceiver from another room or remote location. Allowing you to remotely operate a selected transceiver from another room or remote location. RS-BA1 Version 2 is the latest software of the previous RS-BA1. Shown above in use with a dual-receive transceiver. RS-BA1 Version 2 is the latest software of the previous RS-BA1. The RS-BA1 Version 2 can also still be used with single-receiver transceivers.
The RS-BA1 Version 2 can also enlarge the panel size (normal or large is selectable), buttons added, clickable indicators to change settings, SUB dial added and RIT tuning knob & TX functions added. With the RS-BA1 Version 2, you can use the dual watch operation and spectrum scopes with waterfall function as well as observe the MAIN and SUB spectrum scopes. But this time i cannot reach the remote station. I had to format the PC from the scratch and reinstalled w10 (same as previous installation) and the Icom software. Hi, for several years I used the remote utility without problem to reach my remote station. The S-Meter and SWR can even be observed. ICOM Remote Utility 2.0 (RS-BA1 version 1) QUESTION.
Low voice latency (caused by the RS-BA1) provides the same operational experience as using an actual radio. Most functions and modes of your Icom compatible transceiver can be controlled, including interference rejection functions and IF filter settings. The Icom RS-BA1 v2 IP Remote Control Software allows you to use an Icom compatible radio installed in another room using your home network or even from a remote location over the Internet.
0 kommentar(er)
